Converting Cold Exterior Walls New Britain CT

With the ongoing increases in the price of fuel and electricity, many of us who live in older homes are beginning to see that much of that “charm” has a hidden cost. A poorly insulated room directly leads to higher heating bills and wasted dollars escaping as so much hot air. I'm not recommending everyone with a 1980s or older house tear down all the walls, and start over, but if you're already planning some renovations, this may be a worthwhile extra step.

1. Make any necessary repairs. Ensure all existing studs are stable and add any boards where they will be needed when it's time to install the drywall or curtains. If the wall has already been opened up inside, then work in the house--otherwise it's best to keep the construction (and mess) outside. The rest of this article is written under the assumption you are working inside the structure.

2. Measure your studs. If you are planning on expanding only the vertical studs, you are going to want boards that are long enough to run from floor to ceiling.

3. Assemble your materials. Assuming you are expanding your wall by 2 inches, you will need one length of 2 x 2 lumber (or a 2 x? ripped with a table saw to the appropriate thickness) for each stud. You may want to thicken cross pieces as well, but I have successfully completed this project by using lumber the height of the entire wall. An optional tool is a good instant bond construction adhesive; this will hold your lumber in place as you hammer in the nails and increase the strength of the repair as it dries. You will also need some 3-inch or larger framing nails, a hammer, a level, and a ladder or step stool.

   ...

Click here to read the rest of the article at HowToDoThings.com

Author: Sonia C