Creating A Battery Tester Chicago IL

Steps

1. Get some enamelled copper wire or wire obtained from the inside of a tubelight choke. Don't worry about the length.
2. Wind the wire over a tumbler and remove, so that it takes the form of a spiral.
3. Attach the spiral together by a string at two or more places, leaving the ends open, and fix it vertically over a board.
4. Tie a razor blade with a string horizontally and hang it at the top of the wound coil such that the blade is parallel to the coil.
5. Connect the two ends of the coil to any torch or other battery. The blade should deflect if there is current in it. If not deflected then it is a waste battery.

Tips

• Clean the bare ends of the coil.
• Blade should be parallel to the coil.
• Deflection will be more for a new battery.
• Blade should be at the centre of the coil.

Warnings

• Kids should do with adult supervision

Things You'll Need

• coil,razor blade, string, battery, board for fixing

Sources and Citations

• http://www.geocities.com/omomramram/index.html

Article provided by wikiHow, a wiki how-to manual. Please edit this article and find author credits at the original wikiHow article on How to Create a Battery Tester. All content on wikiHow can be shared under a Creative Commons license.