Do It Yourself Toilet Repair Menomonie WI

2. Now you need to remove the bolts on either side of the base. It is possible that these bolts have rusted and locked. If that is the case then you should apply some breaking solution or use a small hacksaw blade to cut them off. Never use a hammer or other tool to strike the bolts as you run the risk of cracking the base which means a new toilet.

3. Now you need to disconnect the water line from under the tank. Keep a bucket handy to catch any excess water that comes out as the tank will not completely empty with the last flush. A pair of pliers or locking pliers works well for removing the line or a good plumbers wrench in the right size works well also.

4. Once the line is disconnected grab the toilet in the front and the back and lift straight up. It is suggested that you take the toilet outside and lay it on its side. You will need to make sure that the hole in the bottom is clean. Clean off any remnants of the old seal.

5. Clean the old seal off the flange in the floor and apply the new toilet bolts. Bring the toilet back in and apply the new seal to the hole on the bottom of the toilet. Once the seal is in place, replace the toilet to its old position, carefully feeding the bolts through the holes.

6. Once the toilet is seated then you need to thread the nuts onto the toilet bolts but do NOT tighten them down. Sit on the toilet for about five minutes to allow the wax seal to compress and take seat. Once this is done then you can tighten the bolts as they should be, but be careful to not over-tighten as it can crack the base.

7. Attach the water line and turn on the water. Check for leaks and then you are done.