How To Prepare Metal for Painting Mechanicsburg PA

Remove any rust. If your object has any rust then you will want to begin by removing that. Use a wire brush to scrub off as much rust as possible. Wash it with soap and water (dish soap works well) and rinse thoroughly. If this doesn't remove all of the rust then use a commercial rust remover (you can find some in the auto section of many stores). Follow the directions to remove the remaining rust.

If you get flash rust (a light layer of rust that appears while the item is drying) you can spray the item down with WD-40 and rub the rust off with steel wool or a wire brush.

Sand your metal. For a really good finish, find some sand paper made for metal and carefully sand your piece down. Start with a coarse grit paper and work your way down to a fine grit sand paper. Make sure you get into the tight spots as well.

If you have some really tight spots it is a good idea to use a rotary tool such as a Dremel to get into them. Use a sanding bit and carefully work your way into tight spots and clean them out thoroughly.

Prime the metal. Using a primer that is recommended for metals (read the packaging) add a good layer of primer to the metal. You can do this with a brush-on one or a spray-on one. Let the primer dry. Then gently sand the primer. Wash off any dust created using a damp sponge. Finish with a second coat of primer. ...

Click here to read the rest of the article at HowToDoThings.com

Author: Danelle Karth