All Topics > Home Services > Electrical > How To Wire A Light Switch >

How To Wire A Light Switch Georgia

Sometimes it just isn't feasible to hire a professional to do a very small job, such as wiring a lig ...

Local Companies

ojc electrical and plumbing
(404) 484-8054
67-50 peactree ind boulevard
Atlanta, GA

Millennium Electric Company
678-414-8652
PO Box 11462
Atlanta, GA

Good Electric Corporation
770-452-4663
3313 Chamblee Dunwoody Rd
Chamblee, GA

A Plus Electrical
(678) 705-5866
2929 Landrum Dr Sw
Atlanta, GA

ABC Electric Automotive
(678) 502-7014
3365 W Hospital Ave
Atlanta, GA

Atlanta, TEC Electrician (678) 262-2272
(678) 262-2272
101 Sunset Dr
Atlanta, GA

General Labor Service
(770) 306-2487
640 Parkway Rd.
Union City, GA

Electrical Service & Lighting Solutions
678-246-4522
309 Pine st.
Rockmart, GA

Polk Electric, Inc.
678-423-6333
49 Chandler's Run
Newnan, GA

Allison Smith Co
(404) 880-0400
191 Peachtree St Ne
Atlanta, GA

provided by: HandyHouseholdHints.com

Sometimes it just isn't feasible to hire a professional to do a very small job, such as wiring a light switch in your home. Wiring a light switch is fairly easy as long as you follow a few simple steps.

1. Step one: Connect the bare wire, or ground wire, to the electrical box and then cut the wire off about an inch past the ground screw. Connect the black wire to one screw and the white wire, which is the hot wire, to another screw on the switch. (∗This is the ONLY time that you should use the white wire for the conducting wire, or hot wire.)

2. Step two: Most light switches will have a 2 wire #14 cable coming from the light box to the switch. At the light box, you will connect the black wire on the light switch to the black wire on the light itself. You will then connect the white wire on the light switch to the black conducting wire that comes out of the breaker. When you are connecting two wires by splicing them together, you will need to use a connector, called a marret. Make sure that the splice you have completed is strong and electrically sound, just like the original conductor was. NOTE: Sometimes your light switch might not be laid out in this fashion. In other cases, there will be a feeder wire from the breaker that enters the switch box.

3. Step three: Now you will connect the ground wires like you did before. Splice the two white wires together with a marret, and connect the black wire from the breaker to one side of the switch. The other black wire that goes to the light itself will be connected to the opposite side of the switch.

4. Step four: Now, you need to connect the ground wires to the box. You can do this in one of two ways: either put one wire under the ground screw and then use a marret to splice them together or you can put each different wire under a different screw. It is just a matter of preference on this step.

5. Step five: Connect the remaining white wire from the switch to the only silver screw on the light. Connect the remaining black wire from the switch to the brass screw on the light. Make sure that you don't get these wires crossed or going to different screws.

6. Step six: replace all the covers to the light switch and you are finished. Make sure that you test the light out before considering this project complete.

WARNING: When working with electricity, it is always best to completely turn off any electrical circuits that you will be working with before you begin your work. Always follow all safety precautions and directions on the packaging of electrical products that you are working with to prevent injury.

Read full article at HandyHouseholdHints.com

Featured Local Company

ojc electrical and plumbing

4044848054
67-50 peactree ind boulevard
Atlanta, GA
non found

Read more about How To Wire A Light Switch

- Do It Yourself New Wiring Georgia

There are times when new things are added to a home that require some wiring. This is true of a good ...

- How to Install a Garbage Disposal Georgia
- Replace a 3-Way Switch Georgia
- DIY Wiring For Light Fixtures Georgia
- Walkway Lights Georgia
- How To Choose The Right Light Switch Georgia
- Do It Yourself Dimmer Switch Installation Georgia
- Ceiling Fan Options Georgia
- Do It Yourself Outdoor Wiring Georgia
- New Switch Installation Georgia

Regional Articles

- New Switch Installation Georgia

Are you trying to replace a switch in your home? If so, read the following article for some instructions.

- Ceiling Fan Options Georgia
- DIY Wiring For Light Fixtures Georgia
- Do It Yourself New Wiring Georgia
- How To Choose The Right Light Switch Georgia
- Walkway Lights Georgia
- Do It Yourself Dimmer Switch Installation Georgia
- Do It Yourself Outdoor Wiring Georgia
- How to Install a Garbage Disposal Georgia
- Replace a 3-Way Switch Georgia

Related Local Events

TechAdvantage Expo
Dates: 2/12/2010 - 2/15/2010
Location: Georgia World Congress Center, Atlanta
Atlanta, GA
View Details

CEDIA EXPO 2009
Dates: 9/9/2009 - 9/13/2009
Location: Georgia World Congress Center (Atlanta)
Atlanta, GA
View Details

Southern Building Show and Conference 2009
Dates: 6/2/2009 - 6/5/2009
Location: Cobb Galleria Centre
Atlanta, GA
View Details

Advertising	Food & Beverage	Nightlife
Business Services	Franchise	Online Database
Career	Health	Pets
Cars	Holidays	Real Estate Resources
Computer Hardware	Home Appliances	Retail & Consumer Services
Construction	Home Electronics	Software
Education	Home Services	Technology
Entertainment	Industrial Goods & Services	Telecommunications
Environmental	Insurance	Trade Shows
Family	Internet	Travel
Fashion	Legal	Weddings
Financial Services	Miscellaneous	World History

Advertising	Family	Home Services	Real Estate Resources
Business Services	Fashion	Industrial Goods & Services	Retail & Consumer Services
Career	Financial Services	Insurance	Software
Cars	Food & Beverage	Internet	Technology
Computer Hardware	Franchise	Legal	Telecommunications
Construction	Health	Miscellaneous	Trade Shows
Education	Holidays	Nightlife	Travel
Entertainment	Home Appliances	Online Database	Weddings
Environmental	Home Electronics	Pets	World History