How to Install a Hugger Ceiling Fan Martinsville VA

Steps

1. Pull the wires from inside the fan rated box straight down and give them a half to full twist over their entire length.
2. Pass the wires from the box through the opening punched in the fan mounting plate.
3. Secure the fan mounting plate to the fan rated box.
4. Locate the hook on the mounting plate, and hang the fan motor assembly on it by aligning it with one of the mounting holes on the fan motor's flange.
5. Connect the wires between the fan and box with a properly sized wirenut. If electrical tape is needed to keep the wirenut in place, the wrong size wirenut is being used.
6. Place a lock washer / washer on each of the fan motor assembly mounting screws.
7. Inspect the flange of the fan motor assembly. Most have locations for (4) four screws to secure it to the mounting plate. Two (2) of these locations are usually just round holes, while the other two (2) are slotted holes. Note the slotted hole orientation.
8. Install two (2) screws and washers into the threaded holes that will align with the slotted holes of the fan motor assembly flange. Turn them in only until the threaded end has just begin to protrude out of the back side.
9. Slide the washers against the head of the screws.
10. Remove the fan motor assembly from the hanger. Secure it to the mounting plate by aligning the slotted holes of the fan motor assembly's flange with the two (2) screws installed previously in the sides of the mounting bracket. Once aligned, push up and gently twist 1/4 to 1/2 inch so that the flange rests fully on the screws. Do not tighten the screws at this time.
11. Install the other two (2) screws and washers into the round holes of the fan motor assembly flange. Once the last screw has been started through the flange and into the mounting plate, it and the rest can be firmly tightened.
12. Secure fan motor assembly cover to the motor.
13. Secure the fan blades to the brackets with screws or clips provided.
14. Install each blade assembly to the fan motor.
15. If using a light kit, install it and a light bulb. Secure the glass. If not using a light kit, put the cap on it. Snap on the pull chains if not using a remote or wall mounted controls, otherwise you may discard them.
16. Turn light on (if any). If it does not come on - pull either chain (it may be in the off position).
17. Turn fan on starting with low speed - taking any corrective action to eliminate vibrations or rubbing sounds on the way to high speed.

Tips

• Use of light bulbs designed for fans or "vibration service" bulbs will generally outlast regular bulbs in paddle fans.

Warnings

• Always turn power off before attempting this or any other electrical work in your home.
• This wiki has information mostly specific to "hugger" ceiling fans. Merge the information in "Related wikiHow" section below on "How to Install a Ceiling Fan" for a complete installation overview.

Things You'll Need

• 1 Ladder
• 1 Each Phillips and straight blade screwdriver
• 1 Remote control and battery (optional)
• 1 Light kit & bulb(s)(optional)

Article provided by wikiHow, a wiki how-to manual. Please edit this article and find author credits at the original wikiHow article on How to How to Install a Hugger Ceiling Fan. All content on wikiHow can be shared under a Creative Commons license.