provided by: 
A novel chip-making strategy forged by IBM researchers could break through previous constraints, allowing semiconductor makers to use their same basic tools to continue shrinking chip features. If the strategy pans out, it would enable more advances in computing speed and power -- without requiring a long-feared multi-billion-dollar industrial retooling.
The new IBM method boils down to a modification of conventional lithography -- part of the process that converts a silicon wafer to a microprocessor. With this modification, the company can create circuit features that are just 29.9 nanometers wide, down from the 65- and 90-nanometer-wide features of today's mass-produced chips, effectively doubling or tripling chip speed. "The advance is ahead of its time," says Don Bethune, an IBM optics expert who worked on the project.
While IBM may still be years away from actually manufacturing 30-nanometer chips, the announcement last week smashes industry assumptions. Fashioning circuit features much smaller than 45 nanometers was thought to present a serious challenge because the conventional method for etching features in silicon cannot provide the resolution needed. In fact, many researchers assumed that the 32-nanometer mark would probably require entirely new equipment, materials, and facilities.
With today's manufacturing technology, ultraviolet light is shone through a stencil-like "mask" that outlines where the circuit patterns are to be made on the silicon wafer. As the feature sizes on the mask become smaller, the type of light used provides a natural limitation. If the wavelength of light is much larger than the lines in the mask, the resulting features on the silicon are blurry. Currently, ultraviolet light with a wavelength of 193 nanometers is used, and a layer of water and a lens effectively shorten the wavelength of the light and focus it tightly enough to etch circuit features down to about 65 nanometers.
While it might seem obvious to use a shorter wavelength of light, this presents huge challenges for manufacturing, says Bethune. Since air molecules tend to absorb the shorter wavelengths of light, the manufacturing process would have to be conducted in a vacuum and under other special conditions, none of which have been fine-tuned for manufacturing. For these reasons, the semiconductor industry has been trying to stave off this transition for years.
IBM's solution uses the same lithographic process and 193-nanometer light, but with a crucial tweak. The researchers have added a process called "high-index immersion." It replaces the layer of water with a fluid containing complex organic molecules, says Bethune.
This fluid has a higher index of refraction --Â a property that can effectively shorten the wavelength of light --Â than water. In addition, the researchers switched to a lens made from a material that's also better at refracting light than conventional systems. The team optimized its liquid and lens combination on a customized piece of equipment, called Nemo, which tests next-generation lithography materials.
By Kate Greene
Read article at techreview.com